600+ Automobile Engineering MCQ page-4
Question 31:- The parts of the cover assembly that hold the pressure plate against the clutch plate are the (a) release levers (b) thrust bearings (c) struts (d) springs |
Question 32:- Cushioning springs in clutch plate are meant to reduce (a) torsional vibrations (b) vehicle speed (c) jerky starts (d) none of the above |
Question 33:- The thrust bearing should come into contact with the release levers when the (a) vehicle is stationary (b) vehicle is running very fast (c) vehicle is driven very slow (d) clutch pedal is pressed |
Question 34:- In a clutch will coil springs, the wear of the clutch lacing will cause the clamping load to (a) increase (b) decrease (c) remain constant (d) become infinite |
Question 35:- Clutch facings arc usually attached to the plate by (a) steel rivets (b) brass rivets (c) aluminium screws (d) steel screws |
Question 36:- The purpose of transmission in an automobile is (a) to vary the speed of automobile (b) to vary torque at the road wheels (c) to vary the power of auto mobile (d) none of the above |
Question 37:- Increase in torque in a vehicle is obtained by (a) decreasing speed (b) decreasing power (c) decreasing petrol consumption (d) all of the above |
Question 38:- Two advantages of using helical gears rather than spur gears in a transmission are (a) High strength and low cost (b) High strength and less end thrust (c) Low noise level and high strength (d) Low noise level and economy |
Question 39:- The central gear of an epicyclic gear set is called a (a) ring gear (b) sun gear (c) planet gear (d) internal gear |
Question 40:- The component of the torque converter that allows multiplication of torque is the (a) turbine (b) impeller (c) pump (d) stator |