600+ Automobile Engineering MCQ page-2
| Question 11:- The basic automobile structure consists of the suspension system, axles, wheels and (a) steering (b) brakes (c) frame (d) lights |
| Question 12:- Compared to framed construction, the frame less construction of automobiles is economical (a) always (b) when produced in small quantities (c) when produced on large scale (d) never |
| Question 13:- The purpose of gear box in an automobile is to (a) vary speed (b) vary torque (c) provide permanent speed reduction (d) to disconnect the road wheels from the engine when desired |
| Question 14:- The cooling system of automobile engine most simple when the engine is placed at the (a) front (b) centre (c) rear on the left (d) rear on the right |
| Question 15:- In case of a four-wheel driven vehicle (a) clutch operating linkage is simplified (b) cooling system is simplified (c) the road adhesion is increased (d) the road adhesion is decreased |
| Question 16:- The example of a saloon is (a) Premier car (b) Tata truck (c) Leyland bus (d) none of these |
| Question 17:- The example of a hatchback is (a) Maruti 800 (b) Premier Padmini (c) Ambassador Nova (d) Fiat 1100 |
| Question 18:- The number of points at which the engine-clutch-gear box unit is supported on the chassis frame is (a) one (b) two (c) three (d) four |
| Question 19:- The clutch is located between the transmission and the (a) engine (b) rear axle (c) propeller shaft (d) different |
| Question 20:- The most effective section against bending is (a) rectangular bar (b) round bar (c) round hollow tube (d) square hollow section |