Automobile Engineering MCQ page-45
| Question 441:- For fiat 1100 the value of steering ratio is— (A) 14: 1 (B) 164: 1 (C) 24: 1 (D) 1: 12 |
| Question 442:- The caster angle for Ashok leyland is— (A) 1° (B) 3° (C) 7° (D) 9° |
| Question 443:- The camber angle for Jeep CJ-3B is— (A) 1° (B) 112 ° (C) 3° (D) 7° |
| Question 444:- The camber angle for Jeep CJ-3B is— (A) 1° (B) 112 ° (C) 3° (D) 7° |
| Question 445:- The value of b l for correct steering lies between— (A) 0·4 to 0·5 (B) 1·2 to 1·5 (C) 0·1 to 0·2 (D) 1·1 to 1·9 |
| Question 446:- The value of king pin inclination for dodge is— (A) 8° (B) 7° (C) 3° (D) 1° |
| Question 447:- The thickness of the film between the bearing and journal depends upon— (A) Load (B) Speed (C) Type of the lubricant (D) All are correct |
| Question 448:- What is necessary for tuning procedure? (A) Test engine compression (B) Clean and inspect rotor and replace it, if it is not in good condition (C) Check distributor centrifugal advance (D) All are correct |
| Question 449:- Crankshaft thumping may originate from which one of the following cause— (A) Excessive main bearing clearance (B) Excessive crankshaft axial play (C) Low oil pressure (D) All are correct |
| Question 450:- The noises due to connecting rod are usually …… intense than those originated by main bearings. (A) More (B) Less (C) Same (D) None |
45