Automobile Engineering MCQ page-41
| Question 401:- What is the speed ratio of reverse shift position? (A) 3·363 (B) 2·932 (C) 0·999 (D) 0·876 |
| Question 402:- The transfer case is essentially a …… speed transmission. (A) One (B) Two (C) Three (D) Four |
| Question 403:- Noise in gear is due to— (A) Dry rear bearing on main shaft (B) Damaged speedometer drive gear (C) Both (D) None of the above |
| Question 404:- A hum or bowl in neutral is due to— (A) Lack of lubrication (B) Worn shaft (C) Worn bearings (D) All are correct |
| Question 405:- Oil leaks from the gear box due to the following reasons— (A) Too high oil level in case (B) Loose cover bolts (C) Loose drain or filler plug (D) All are correct |
| Question 406:- Hard shifting occurs due to— (A) Distorted splines of the main shaft (B) Too strong shifter lock spring (C) Battered gear teeth (D) All are correct |
| Question 407:- Slipping out of gear is due to— (A) Too much clearance between teeth in mesh (B) Insufficient mesh or gears (C) Weak shifter lock spring (D) All are correct |
| Question 408:- To turn the drive at 90° and to give the required speed reduction, the basic type of gearing is— (A) Bevel gear (B) Worm and worm wheel (C) Both (D) None |
| Question 409:- The worm and worm wheel arrangement for final gear reduction is extremely— (A) Weak (B) Strong (C) Same (D) None of these |
| Question 410:- The transversely mounted engine does not require its final drive turned through— (A) 180° (B) 0° (C) 60° (D) 90° |
41