Automobile Engineering MCQ page-40
| Question 391:- Which of the following is a type of draw bar? (A) Regular draw-bars (B) Three point linkage draw bar (C) Both are correct (D) None of these |
| Question 392:- To control the depth of implement to safe limit which of the following methods are employed? (A) Depth wheel (B) Hydraulic depth control (C) Both are correct (D) None of these |
| Question 393:- Which of the following is a type of pumps? (A) Plunger pump (B) Gear pump (C) Vane pump (D) All are correct |
| Question 394:- The used valve (Hydraulic valve) is— (A) Spool valve (B) Rotary valve (C) Both are correct (D) None of these |
| Question 395:- Tappet clearance for 4-stroke engine is usually kept at …… for inlet. (A) 0·003″ (B) 0·004″ (C) 0·005″ (D) 0·006″ |
| Question 396:- Tappet clearance for 4-stroke engine is usually kept at …… for exhaust. (A) 0·003″ (B) 0·004″ (C) 0·005″ (D) 0·008″ |
| Question 397:- What is the remedy of the cause ”Fault ignition timing”? (A) Set it correctly (B) Clean it (C) Overhaul the carburettor (D) Tight cylinder head nuts properly |
| Question 398:- What is the speed ratio of second shift position? (A) 3·583 (B) 2·166 (C) 0·999 (D) None |
| Question 399:- What is the speed ratio of top shift position? (A) 3·589 (B) 2·166 (C) 0·999 (D) None |
| Question 400:- What is the gear ratio of reverse shift position? (A) 37/22 × 22/11 (B) 27/30 (C) 27/20 × 11/30 (D) None |