600+ Automobile Engineering MCQ page-74
| Automobile Engineering MCQ |
|---|
| Question 681: ‘What is the best word to describe the assembled parts of a clutch? Options : A. Welded B. Bolted C. Riveted D. Solder |
| Automobile Engineering MCQ |
|---|
| Question 682:- A clutch that consists of thin plates immersed in a bath of oil and has grooved surfaces for permitting the oil to flow through these plates is called: Options : A. Multiple dry clutch B. Multiple wet clutch C. Semi-centrifugal clutch D. Centrifugal clutch |
| Automobile Engineering MCQ |
|---|
| Question 683:- A pilot bearing that is worn or lacks lubricant will produce noise in the clutch when which condition exists? Options : A. Transmission is in gear B. Clutch is disengaged C. Vehicle is standing still D. Clutch is engaged |
| Automobile Engineering MCQ |
|---|
| Question 684:- ‘Which of the given statements are correct? 1. In the SI engines, detonation occurs near the end of combustion; whereas in CI engines, knocking occurs near the beginning of combustion. 2. In SI engines, no problems are encountered on account of pre-ignition. 3. Low inlet pressure and temperature reduce knocking tendency in SI engines but increase the knocking tendency in CI engines. Options : A. 1,2 and 3 B. Only 1 and 2 C. Only 2 and 3 D. Only 1 and 3 |
| Automobile Engineering MCQ |
|---|
| Question 685:- The output of an ignition coil is connected to which of the following parts? Options : A. Battery B. Ammeter C. Distributor cap D. Spark plug |
74