Automobile Engineering MCQ page-41

Question 401:- What is the speed ratio of reverse shift position?
(A) 3·363
(B) 2·932
(C) 0·999
(D) 0·876

Question 402:- The transfer case is essentially a …… speed transmission.
(A) One
(B) Two
(C) Three
(D) Four

Question 403:- Noise in gear is due to—
(A) Dry rear bearing on main shaft
(B) Damaged speedometer drive gear
(C) Both
(D) None of the above

Question 404:- A hum or bowl in neutral is due to—
(A) Lack of lubrication
(B) Worn shaft
(C) Worn bearings
(D) All are correct

Question 405:- Oil leaks from the gear box due to the following reasons—
(A) Too high oil level in case
(B) Loose cover bolts
(C) Loose drain or filler plug
(D) All are correct

Question 406:- Hard shifting occurs due to—
(A) Distorted splines of the main shaft
(B) Too strong shifter lock spring
(C) Battered gear teeth
(D) All are correct

Question 407:- Slipping out of gear is due to—
(A) Too much clearance between teeth in mesh
(B) Insufficient mesh or gears
(C) Weak shifter lock spring
(D) All are correct

Question 408:- To turn the drive at 90° and to give the required speed reduction, the basic type of gearing is—
(A) Bevel gear
(B) Worm and worm wheel
(C) Both
(D) None

Question 409:- The worm and worm wheel arrangement for final gear reduction is extremely—
(A) Weak
(B) Strong
(C) Same
(D) None of these

Question 410:- The transversely mounted engine does not require its final drive turned through—
(A) 180°
(B) 0°
(C) 60°
(D) 90°

41

Shopping Cart
Scroll to Top
Talk to Me
1
Hi, Ask me anything regarding your exam
Scan the code
Help Desk
Hi, Ask me anything regarding your exam preparation.